The major operation of our company is the fabrication of precise parts by subjecting various kinds of metals to chemical milling on the basis of 0.005～0.1t which are the critical point of stamping processing.
Of course we accept an order to extend than 1.00t.

◎It is a more advantageous point in comparison with the stamping processing such as accurasy and unit price by chemical milling. (a)
If the plate thickness of 0.3t or below accuracy be demand especially.

(b)
If needs to be made the dot and lines that smaller than the thickness into a part of the parts.

(c)
It is the one that the die price becomes to the product cost an overweight addition for a small lots production, even though if it is suited to stamping processing basically.
(the prototype and also a small lots production.)

(d)
The time needed from designing until production is shorter than the time of die production.
(Quick delivery)

(e)
It is in the case of used the material that has the fear that causes the change for a state nature by the impact of stamping processing.

(f)
In the case of very small parts or dozens piece molding etc. Being possible that set the dozens piece into one frame and make the product with one process by using jig the mass production and the saving of manpower become possible.